Vulcan-Hart EV12 Series Installation & Operation Manual page 7

3. Attach mounting plate to bottom of range using four ¼ - 20 x ⅝" self tapping screws (provided). If
casters are being installed, the locking casters should be mounted on the front.
4. After all legs/casters have been installed, carefully return the range to its upright position.
(For additional leg information, see Leveling section of this manual).
A permanently connected appliance mounted on casters and intended to be secured to the building structure
should adhere to the following:
a. Adequate means must be provided to limit the movement of the appliance without depending on or
transmitting stress to the electrical conduit;
b. The location(s) where restraining means are to be attached to the appliance needs to be on the outside
rear parts of the oven chassis frame of the Range (where the bottom rear heat shield is bolted to the
Range). Use brackets provided as connection points as shown below.
c. The appliance shall be installed using a flexible conduit.
If the range is installed on casters and is moved for any reason, it is recommended that the range be re-leveled
front to back and side to side for even baking.
Model ESB Broiler
For installation of an ESB on a range, it is necessary to also replace the standard plate shelf with a reinforced
shelf, also sold separately. Once obtained, mount the reinforced shelf according to the included instructions. The
ESB then mounts to the shelf with hardware provided. The ESB will have an independent electrical hookup.
Restraining Connection Bracket
7 F-38251 (08-09) REV D