Sony Handycam HDR-FX1000 Operating Manual page 117

N To clean the LCD screen
If fingerprints or dust make the LCD screen
dirty, it is recommended you use a soft
cloth to clean it. When you use the LCD
Cleaning Kit (optional), do not apply the
cleaning liquid directly to the LCD screen.
Use cleaning paper moistened with the
liquid.
Onhandling the casing
• If the casing is soiled, clean the camcorder body
with a sul: cloth lightly moistened with water,
and then wipe the casing with a dry sufl cloth.
• Avoid the following to avoid damage to the
finish.
Using chemicals such as thinner, benzine.
alcohol, chemical cloths, repellent, insecticide
and sui1screen.
Handling with above substances on your
hands.
Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
About careandstorage of thelens
• Wipe the surface of the lens clean with a sol:
cloth in the following instances:
When there are fingerprints on file lens
surlace.
In hot or humid locations
When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a munth to
keep it in optimum state for a long time.
Oncharging t hepre-installed
rechargeahle b attery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet (wall socket) via the AC
Adaptor or while the battery pack is
inserted. The rechargeable battery will be
fully discharged in about 3 months if you
do not use your camcorder at all without the
AC Adaptor connected or the battery pack
attached. Use your camcorder after
charging the pre-installed rechargeable
battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
N Procedures
Connect your camcorder to a wall outlet
(wall socket) using the supplied AC
Adaptor, and leave it with the POWER
switch set to OFF (CHG) for more than 24
hours.
g
g_
m
Continuod,,*
117