Service And Repairs; Seat (Sp 2020/3020) - Toro Sand Pro 2020 Service Manual

Service and Repairs

Seat (SP 2020/3020)

15
14
11
1. Seat
2. Cap screw
3. R–clamp
4. Flat washer
5. Manual tube
6. lock nut
Removal
1. Park machine on a level surface, engage the park-
ing brake, lower attachment, and stop engine.
2. Lift seat up. Remove four cap screws from seat
plate and seat. Separate seat from plate. Make sure not
to lose four spacers.
3. Remove seat plate from frame by removing lock
nuts, cap screws and flat washers from the angle brack-
ets and seat clamps.
Sand Pro 2020/3020/5020
16
10
9
Figure 5
7. Cap screw
8. Seat clamp
9. Service decal
10. Rubber cushion
11. Seat plate
Page 6 – 5
1
2
4
12
6
13
7
8
6
12. Angle bracket
13. Spacer
14. Lock nut
15. Seat base shield
16. Cap screw
Installation
1. Install seat plate to frame by securing plate to angle
brackets and seat clamps with cap screws, flat washers,
and lock nuts. Secure manual tube and R–clamps to
angle bracket with cap screws, flat washers, and lock
nuts.
2. Position seat and spacers to seat plate. Insert cap
screws through plate and spacers. Screw cap screws
into seat and tighten.
3. Replace rubber cushions if worn or damaged.
Wheels, Brakes,and Miscellaneous
5
3
2
4