Front Wheel (Sp 2020) - Toro Sand Pro 2020 Service Manual

Front Wheel (SP 2020)

5
7
6
3
4 5
9
RIGHT
FRONT
1. Hex nut
2. Lock washer
3. Carriage bolt
4. Set screw
5. Bearing flange
Removal (Fig. 6)
1. Park machine on a level surface, engage parking
brake, lower attachment, and stop the engine.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
2. Jack up front fork enough to allow the bearing
flanges and front axle to drop free of the fork.
3. Loosen set screws on both locking collars; Unlock
collar by turning against the direction of shaft rotation.
4. Remove hex nuts and lock washers from carriage
bolts securing the bearing flanges to the front fork.
Wheels, Brakes, and Miscellaneous
12
8
14
Figure 6
6. Bearing
7. Locking collar
8. Tire
9. Front axle
10. Front fork
Page 6 – 6
1
2
13
11
4
3
11. Lug nut
12. Drive stud
13. Wheel rim
14. Valve stem
Support wheel and shaft when removing car-
riage bolts from the front fork and bearing
flanges to prevent personal injury.
5. Remove carriage bolts from bearing flanges and
front fork. Lower front wheel from fork.
6. Slide bearing flanges and bearings off the front axle.
7. Separate bearing flanges from the bearings.
8. Remove lug nuts from the drive studs. Separate
front axle from wheel rim.
10
2
1
5
6
7
5
CAUTION
Sand Pro 2020/3020/5020