Brake Linkages (Sp 2020/3020) - Toro Sand Pro 2020 Service Manual

Brake Linkages (SP 2020/3020)

1
5
RIGHT
FRONT
1. Cap screw
2. Lock nut
3. Brake lever
4. Spacer
5. Clevis pin
6. Flat washer
7. Cotter pin
Most parking brake linkage parts can be repaired or re-
placed without removing any interference. However, the
lift valve shroud must be removed to work on the parking
brake lever.
CAUTION
The muffler and exhaust pipe may be hot. Avoid
possible burns; allow engine and exhaust sys-
tem to cool before working near muffler.
1. Remove knob from the lift lever. Remove both lock
nuts and cap screws securing the lift valve shroud, lift le-
ver guide, and lift lever latch (Fig. 26).
2. Remove bottom front cap screw securing the lift
valve shroud to the frame. Pull shroud from the frame
(Fig. 26).
IMPORTANT:When removing the clevis from either
the brake rod or brake lever or the brake lever from
the cam shaft on the brake assembly, make sure to
matchmark both parts. Marking both parts will make
reassembly and brake adjustment easier.
Wheels, Brakes, and Miscellaneous
3
4
2
7
6
8
9
10
11
7
12
13
14
15
16
Figure 10
8. Clevis
9. Jam nut
10. Brake rod
11. Adjusting rod
12. Roll pins
13. Spacer
14. Flat washer
Page 6 – 12
20
19
8
9
18
21
7
17
15. Side flange bearing
16. Cap screw
17. Brake arm
18. Adjusting rod
19. Cotter pin
20. Brake lever (to brake assembly)
21. Clevis pin
1
4
3
1. Knob
2. Lock nut & cap screw
3. Lift valve shroud
3. Remove and replace parts as necessary to repair
brake linkages (Fig. 10).
4. Reinstall lift lever latch, lift lever guide, lift valve
shroud, and knob (Fig. 26).
IMPORTANT:Always check and adjust the brakes
anytime brake linkages are disassembled or re-
paired (see Brake Adjustment).
2
5
Figure 11
4. Lift lever guide & latch
5. Cap screw
Sand Pro 2020/3020/5020