Brake Linkages (Sp 5020) - Toro Sand Pro 2020 Service Manual

Brake Linkages (SP 5020)

24
23
22
17
21
20
21
20
19
18
RIGHT
FRONT
1. Curved washer
2. Lever bracket
3. Lock nut
4. Lock nut
5. Clevis pin
6. Lock nut
7. Side flange bearing
8. Hex head flange
9. Roll pin
10. Brake arm
11. Left bearing bracket
Most parking brake linkage parts can be repaired or re-
placed without removing any interference. However, the
right fender must be removed to work on the parking
brake lever.
CAUTION
The muffler and exhaust pipe may be hot. Avoid
possible burns; allow engine and exhaust sys-
tem to cool before working near the muffler.
1. Remove right fender if necessary (see Right Fender
Removal).
Sand Pro 2020/3020/5020
1
2
3
4
5
17
25
4
16
15
14
13
11/12
Figure 12
12. Right bearing bracket
13. Washer head screw
14. Flat washer
15. Cotter pin
16. Traverse rod
17. Cotter Pin
18. Clevis pin
19. Strap
20. Cap screw
21. Flat washer
22. Lever assembly
Page 6 – 13
6
7
8
9
10
26
28
27
29
31
32
23. Cap screw
24. Spacer
25. Hourmeter bracket
26. Cotter pin
27. Adjustment rod
28. Jam nut
29. Adjustment clevis
30. Clevis pin
31. Cotter pin
32. Brake lever
IMPORTANT:Make sure to matchmark both parts
when removing the clevis from either the brake rod
or brake lever or removing the brake lever from the
cam shaft on the brake assembly, . Marking both
parts will make reassembly and brake adjustment
easier.
2. Remove and replace parts as necessary to repair
brake linkages (Fig. 12).
3. Reinstall right fender if necessary (see Right Fender
Installation).
IMPORTANT:Always check and adjust the brakes
anytime brake linkages are disassembled or re-
paired (see Brake Adjustment).
Wheels, Brakes,and Miscellaneous
30