Toro Sand Pro 2020 Service Manual page 37

Muffler Installation
1. Position muffler through the bottom of the machine
to the muffler bracket. Insert cap screw with flat washer
through the muffler tab and then the muffler bracket.
Screw hex nut onto the cap screw, but do not tighten
(Fig. 30).
2. Attach exhaust tube to the muffler. Attach exhaust
tube to the exhaust manifold (Fig. 31).
3. Make sure exhaust tube fits snugly to both the muf-
fler and exhaust manifold. Secure exhaust tube to the
exhaust manifold and muffler with muffler clamps (Fig.
31).
4. Tighten cap screw and hex nut securing the muffler
to the muffler bracket (Fig. 30).
5. Secure R–clamp and muffler shield to the engine
with three cap screws and star washers (Fig. 29).
6. Position traverse rod to the frame. Make sure each
side flange bearing is on the inside of the frame. Secure
bearings to the frame by tightening both hex flange head
screws on each bearing (Fig. 28).
7. Connect brake rod to the traverse rod lever. Secure
brake rod with cotter pin (Fig. 28).
8. Connect adjusting rods to both brake arms. Secure
both adjusting rods with a cotter pin (Fig. 27).
9. Secure top of lift valve shroud, lift lever guide, and
lift lever latch to the frame with both cap screws and lock
nuts. Make sure nylon lift lever guide is placed on top of
metal lift lever latch (Fig. 26).
10. Secure bottom of shroud to frame with cap screw.
Screw knob onto lift lever (Fig. 26).
11. Lower rear wheels to the ground after removing
blocks.
Sand Pro 2020/3020/5020
1
2
1. Cap screw & star washer
1. Lock nut & cap screw
2. Muffler
1
1. Muffler clamps
2. Exhaust tube
Page 3 – 17
Figure 29
2. Muffler shield
2
3
1
Figure 30
3. Muffler bracket
3
2
Figure 31
3. Muffler
1
Engine