Front Wheel (Sp 3020 And Sp 5020) - Toro Sand Pro 2020 Service Manual

Front Wheel (SP 3020 and SP 5020)

5
14
1
6
RIGHT
15
FRONT
1. Set screw
2. Locking collar
3. Cap screw
4. Lock nut
5. Relube flangette
6. Flangette
NOTE: The front wheel motors and wheels on the SP
3020 and SP 5020 are attached to the front fork in the
same manner. Therefore the same procedures can be
use for removal and installation.
Removal (Fig. 7)
1. Park machine on a level surface, engage parking
brake, lower attachment, and stop the engine.
2. Loosen both set screws on the locking collar.
3. Support front of the machine. Remove three cap
screws and lock nuts securing the flangettes and bear-
ing tab to the fork.
4. Remove both socket head screws and lock nuts se-
curing the hydraulic motor the fork.
IMPORTANT: Support wheel and motor when jack-
ing up the front fork to prevent dropping and dam -
aging the motor.
Wheels, Brakes, and Miscellaneous
4
2
3
7
Figure 7
7. Bearing tab
8. Front fork
9. Socket head screw
10. Lock nut
11. Hydraulic motor
12. Front wheel
Page 6 – 8
12
13
17
16
13. Spindle
14. Bearing
15. Lug nut
16. Drive stud
17. Wheel hub
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
5. Jack up fork slowly until the hydraulic motor and
flangettes can be removed from the fork. Remove flan-
gettes, spindle, wheel, and motor from the fork.
6. Slide flangettes and bearing assembly from the
spindle. Separate flangettes from the bearing.
7. Remove four lug nuts from the drive studs. Remove
wheel from the drive studs and spindle. Separate
spindle from drive studs and wheel hub.
8. Secure hydraulic motor and hub to the machine to
prevent damaging the hydraulic lines.
8
9
10
11
Sand Pro 2020/3020/5020