Mid-Mount Telco Rack; Installing The Chassis Into A Rack In Mid-Mount Position - Supero SC512 Chassis Series User Manual

M/B

Mid-Mount Telco Rack

The SC512.supports Telco rack installation. The SC512 chassis compact design
allows the chassis to be installed into a Telco rack without the use of rails.
Pan head
6-32 x 5 mm
[0.197]
DVD-ROM CD-ROM FLOPPY DRIVE
Pan head
6-32 x 5 mm
[0.197]
RAIL
Flat head
M4 x 4 mm
[0.157]
M/B STANDOFF
Figure 6-6: Moving the Chassis Ears for Telco Rack Installation

Installing the Chassis into a Rack in Mid-Mount Position

Instaling into a Mid-Mount Position Rack
M/B standoff
6-32 to 6-32
1. If it is necessary to install the chassis in a mid-mount Telco rack, remove the
chassis rails and the chassis ears (if the ears are installed at the front of the
chassis).
2. Locate the three screw holes in the middle of the chassis and secure the ears
to the chassis with three flat head screws. Make sure the screws are secure,
but do not over tighten the screws.
Flat head
6-32 x 5 mm
[0.197]
Round head
M4 x 4 mm
[0.157]
M/B (CPU) standoff
M5 to 6-32
6-9
Chapter 6: Rack Installation
HARD DRIVE
Flat head
6-32 x 5 mm
[0.197]
Place chassis
Round head
3 x 5 mm
[0.197]
Flat head
M5 x 12 mm [0.472]
Washer for M5
Thumb screw
6-32 x 5 mm [0.197]
ears here
Round head
2.6 x 5 mm
[0.197]