SC512 Chassis Manual
5-3
Removing the Chassis Cover
Remove these screws
HARD DRIVE
Flat head
6-32 x 5 mm
[0.197]
Round head
Removing the Chassis Cover
3 x 5 mm
[0.197]
1.
Remove the screws holding the chassis cover in place.
2.
Apply pressure to the middle front of the chassis cover.
3.
Slide the cover toward the rear of the chassis.
!
Flat head
M5 x 12 mm [0.472]
Washer for M5
Figure 5-1: Removing the Chassis Cover
Round head
2.6 x 5 mm
[0.197]
Warning: Except for short periods of time, do NOT operate the
server without the cover in place. The chassis cover must be in
place to allow proper airflow and prevent overheating.
Remove these screws
5-2
Remove this screw