Table of Contents
Advertisement
SC512 Chassis Manual
Expansion Slot Setup
SC512 chassis includes a slot for one full height/full length add-on card and a riser
card. The riser card allows the expansion card to fit within the small 1U form.
The expansion card slot does not require a screw to hold the card in place.
Installing Expansion Cards
1.
Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover.
2.
Slide the add-on card clip upward.
3.
Slide the add-on card slot shield toward the side of the chassis and remove
the Shield.
4.
Secure the riser card to the motherboard.
5.
Slide the add-on card (with "L" bracket) into the add-on card slot and the riser
card.
6.
Replace the add-on card slot clip to secure the add-on card.
Add-on Card Slot Latch
Expansion Card
Slot Shield
Figure 5-8: Installing the Expansion Card
5-8
Advertisement
Table of Contents
