Supero SC512 Chassis Series User Manual page 44

SC512 Chassis Manual
M/B
Pan Head
6-32 x 5mm Pan head
[0.197]
6-32 x 5 mm
[0.197]
DVD-ROM CD-ROM FLOPPY DRIVE
Replacing the Power Supply
1. Disconnect the power cord from the from the chassis to ensure that the unit is
not accidentally plugged in.
Pan head
2. Place the chassis on a stable hard surface and remove the chassis cover.
6-32 x 5 mm
[0.197]
3. Disconnect the power supply from the motherboard and other chassis compo-
RAIL
nents.
4. Remove the screws securing the power supply. Two screws are in the back
of the chassis and one underneath. Retain the screws and the internal brace
that connects the power supply to the chassis from underneath.
5. Pull the power supply out of the chassis.
Flat head
M4 x 4 mm
6. Place the new power supply into the chassis and secure the power supply
[0.157]
using the three screws and internal brace.
M/B STANDOFF
7. Connect the power supply to the motherboard and other chassis components.
8. Connect the power cord to the power supply and power up the chassis/server.
9. Once you confirm that the power supply has been installed correctly, replace
M/B standoff
the chassis cover.
6-32 to 6-32
Figure 5-12: Removing the Power Supply
Flat head
6-32 x 5 mm
[0.197]
Round head
M4 x 4 mm
[0.157]
M/B (CPU) standoff
M5 to 6-32
HARD DRIVE
Flat head
6-32 x 5 mm
[0.197]
Round head
3 x 5 mm
[0.197]
Flat head
M5 x 12 mm [0.472]
Washer for M5
Thumb screw
6-32 x 5 mm [0.197]
5-14
Remove these screws
Power Supply
Remove this screw
Round head
2.6 x 5 mm
[0.197]