Table of Contents
Advertisement
Replacing the Chassis LED Panel
In the unlikely event that the chassis LED and buttons fail, you can replace the panel.
Replacement parts can be ordered from Supermicro or an authorized reseller.
Replacing the Chassis LED Panel
1.
Power down and unplug the system.
2.
Remove the chassis cover.
3.
Disconnect the cord to the front panel.
4.
Locate and remove three screws holding the panel in place. (If your chassis
supports dual hard drives, you may have to remove the second hard drive
from the chassis).
5.
Install the new LED panel and secure the unit with three screws.
6.
Reconnect the cables to the LED panel and if necessary, replace the hard
drive.
Figure 5-13: Replacing the LED Panel
5-15
Chapter 5: Chassis Setup and Maintenance
Advertisement
Table of Contents
