Notes On Executing Program - Fujitsu SOFTUNE User Manual

2.2.2

Notes on Executing Program

There are some precautions to observe when using program execution commands.
■ Real-time Functionality in Running Program
When the MCU is in the full trace mode, there are some cases when a program cannot execute in real-time.
The MCU operation mode can be set up by using either the [Emulation] tab in debug environment setting
dialog, or the SET RUNMODE command in the Command window.
■ Precaution on executing the delay branch instruction
If the delay branch instruction is executed in one of the following procedures, the instruction (just after the
delay branch instruction) placed in the delay slot is executed, and a break is set just after the delay branch
instruction was executed.
• [Debug] - [Run] - [Step In] menu
• [Debug] - [Run] - [Step Over] menu
■ Restrictions when Suspended by Software Break
When there is a software break at the current PC location, if either the [Debug] - [Run] - [Go] menu or the
Go command is executed, the emulator debugger (MB2197) performs one execution step internally, and
then executes the program in batch processing. In addition, when a software break is set for the instruction
to clear the T-flag, and when either the [Debug] - [Run] - [Go] menu or the Go command is executed from
that address, all software breaks are disregarded. When this happens, any interrupt is masked too.
■ Value of TBR Register
Note a program null-function may occur if you specify such value for the TBR register as the vector table
overlaps to the I/O area.
■ Precautions on executing the instruction for clearing flag T
If one of the following procedures is executed, the instruction for clearing flag T is executed continuously.
All software breaks are then ignored.
• [Debug] - [Run] - [Step In] menu
• [Debug] - [Run] - [Step Over] menu
CHAPTER2 Dependence Functions
71