Forced Break - Fujitsu SOFTUNE User Manual

2.3.4.8

Forced Break

This function forcibly aborts the program execution to generate a break.
■ Forced Break
This function forcibly aborts the program execution to generate a break.
When the forced break occurred, the following message appears at the status bar.
Break at address by command aborts request
■ How to Generate
A forced break is generated in the following methods:
• Menu
[Debug] - [Abort] menu
For details, refer to "4.6.2 Abort" in "SOFTUNE Workbench Operation Manual".
• Command
- ABORT
For details, refer to "2.2 ABORT" in "SOFTUNE Workbench Command Reference Manual".
Note:
The forced break cannot be generated when the MCU is the low power consumption mode or in the
hold state. If the MCU is in low power consumption mode or in the hold state when the strong break
is requested by the [Debug]-[Abort] menu during the program execution, the [Debug]-[Abort] menu is
ignored. To generate a break forcibly, used the [Debug]-[Abort] menu to remove a factor by the user
system or use the [Debug]-[Reset of MCU] menu to remove it. If the MCU enters the low power
consumption mode or the hold state during the program execution, the condition is displayed at the
status bar.
CHAPTER2 Dependence Functions
121