Security - Fujitsu SOFTUNE User Manual

2.4.1.3

Security

This section describes the security.
■ Security
When beginning to debug it when the security function of target MCU is effective, it is necessary to enter
the password in the emulator debugger (MB2100-01).
For information of security function, refer to the Hardware Manual for the product type you are using.
■ How to enter
When a dialog shown below is displayed, enter a preset password. The password is needs to be entered
each time the debugger is activated.
For details of password, refer to "the description of Password" in chapter "OCD (On Chip Debugger)" of
the hardware manual of the product you are using.
Notes:
• When authentification of the password has failed, the debugger cannot be activated. Turn on
again the power supply of the target to activate the debugger again.
• If the user system enters a bus sleep state, release the bus sleep state and press the OK button.
For details of the bus sleep, refer to the Hardware Manual for the product type you are using.
Figure 2.4-3 Debugger Connection Password
CHAPTER2 Dependence Functions
155