Memory Locations And Replacement Procedures; Dimm/Dram Simm Locations (For 4H4282-49, 4H4283-49, 4H4284-49 - Enterasys Gold Distributed Forwarding Engine 4H4202-72 Hardware Installation Manual

Memory Locations and Replacement Procedures

In the event that the Dual In‐line Memory Module (DIMM) or DRAM Single In‐line
Memory Module (SIMM) (FLASH memory) needs to be replaced, the following sections
describe how to access, locate and replace these memory modules.
If you have questions concerning the replacement of either memory module, refer to
"Getting Help" on page xviii for details on how to contact Enterasys Networks.
Location of DIMM and DRAM SIMM Memory Modules
Figure B‐5 and Figure
main board. Although 4H4282‐49
applies to the 4H4283‐49 and 4H4284‐49.
the 4H4203‐72, and Figure
Figure B-5
1 DRAM SIMM
Note: Because of the complexity of correctly replacing the large daughter board on the
4H4202-72, there is no procedure in this manual for replacing the DIMM on a 4H4202-72.
Contact Enterasys Networks support or nearest representative if you need to replace the
DIMM.
B‐6 show the locations of the DIMM and DRAM SIMM on each
B‐7 shows the approximate locations on the 4H4202‐72.

DIMM/DRAM SIMM Locations (for 4H4282-49, 4H4283-49, 4H4284-49)

2 DIMM
Memory Locations and Replacement Procedures
is shown in Figure B‐5, the approximate location also
Figure B‐6 shows the approximate locations on
3 Main PC board (4H4282-49 is shown)
Matrix DFE-Gold Series Modules Hardware Installation Guide B-5
➂
➁
➀