Memory Locations And Replacement Procedures; Mode Switch Location (7H4385-49 Shown Without Safety Cover - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Memory Locations and Replacement Procedures

Figure B-1

Mode Switch Location (7H4385-49 shown without safety cover)

À
1 2 3 4 5 6 7 8
ON
1 Mode switch pack (7H4385-49 shown without safety cover)
Memory Locations and Replacement Procedures
If the Dual In‐line Memory Module (DIMM) or DRAM Single In‐line Memory Module
(SIMM) (FLASH memory) needs to be replaced, the following sections describe how to
access, locate, and replace these memory modules. If you have questions concerning the
replacement of either memory module, refer to "Getting Help" on page xviii for details
on how to contact Enterasys Networks.
Figure B‐2 shows the DIMM and DRAM SIMM locations on the main PC board.
DFE-Platinum Series Hardware Installation Guide B-3