Table of Contents
Advertisement
Installation Site Requirement
Installation Site Requirement
The DFE‐Gold module must be installed in a Matrix E7, N1, N3, N5, or N7 chassis located
in a Restricted Access Location (RAL). This location should only be accessible by people
that have been trained or are technically competent enough to be aware of potential risks
of accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or
locked cabinet meet this requirement.
Unpacking the DFE-Gold Module
Unpack the DFE‐Gold module as follows:
1.
Open the box and remove the packing material protecting the DFE‐Gold module.
2.
Verify the contents of the carton as listed in Table
Table 3-1 Contents of DFE-Gold Module Carton
Item
DFE-Gold module
Installation Guide
Customer Release Notes
3.
Remove the tape seal on the non‐conductive bag to remove the DFE‐Gold module.
4.
Perform a visual inspection of the DFE‐Gold module for any signs of physical
damage. Contact Enterasys Networks if there are any signs of damage. Refer to
"Getting Help" on page xviii for details.
3-2 Installation
Warning: Install this module in a Matrix E7, N1, N3, N5, or N7 chassis that has been
installed in a Restricted Access Location only. Access to the equipment by users must be
restricted through the use of a tool or lock and key or other means of security and is
controlled by the authority responsible for the location.
Advertencia: Instalar este modulo en un Matrix E7, N1, N3, N5, o N7 que ha sido
localizado en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem E7, N1, N3, N5, oder N7
Chassis, wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich
zu den Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen
Sicherungen geschützt und durch einen Verantwortlichen kontrolliert werden.
3‐1.
Quantity
1
1
1
Advertisement
Table of Contents
Troubleshooting
