MEMORY LOCATIONS AND REPLACEMENT PROCEDURES
In the event that the Dual In‐line Memory Module (DIMM) or DRAM Single In‐line
Memory Module (SIMM) (FLASH memory) needs to be replaced, the following sections
describe how to access, locate and replace these memory modules. If you have questions
concerning the replacement of either memory module, refer to "Getting Help" on
page xviii for details on how to contact Enterasys Networks.
Location of DRAM SIMM and DIMM Memory Modules
Figure B‐3 and Figure
main board of the 7G4202‐60 and the 7G4282‐41, respectively.
Figure B-2
➀
DIMM
1. This is not considered a field replaceable unit on the 7G4202-60.
B‐2 show the locations of the DRAM SIMM and DIMM on the each
Memory Module Locations on the 7G4202-60
1
Enterasys Matrix DFE-Platinum Series Hardware Installation Guide
Memory Locations and Replacement Procedures
➁
DRAM SIMM
Â
Á
À
➂
Main PC board
B-3