Memory Locations and Replacement Procedures
•
Switch 7 – Clear Persistent Data. Changing the position of this switch clears Persistent Data on
the next power‐up of the module. All user‐entered parameters, such as the IP address, module
names, etc., are reset to the factory default settings. Once the module resets, you can either use
the factory default settings or reenter your own parameters.
•
Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Figure B-1
1 Mode switch pack is in the same location on both DFE-Platinum modules (7G4202-72 shown)
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory
Module (SIMM) (FLASH memory) needs to be replaced, the following sections describe how to
access, locate and replace these memory modules. If you have questions concerning the
replacement of either memory module, refer to "Getting Help" on page xiii for details on how to
contact Enterasys Networks.
B-2 Mode Switch Bank Settings and Optional Installations
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.
Mode Switch Location on 7G4202-72 and 7G4282-49
À
À