Enterasys Gold Distributed Forwarding Engine 4H4202-72 Hardware Installation Manual page 66

Using LANVIEW
Table 4-1 LANVIEW LEDs (continued)
LED
RX
(Receive)
TX
(Transmit)
4-6 Troubleshooting
Color State
None No link. No activity. Port
enabled or disabled.
Green Solid. Link present, port
enabled, no traffic is being
received by the interface.
Amber Flashing. Link present, port
enabled, traffic is being
received by the interface.
Rate of flashing indicates the
data transmission rate.
Red Flashing. Fault or Error
(collision).
None Port enabled, but no activity.
Green Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
Red Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Recommended Action
None.
None.
None.
Contact Enterasys Networks for
technical support.
If it is known that the port should be
active and is not, contact Enterasys
Networks for technical support.
None.
None, unless there is a high rate of
activity. In this case, check for network
configuration problems or a defective
device.