Table of Contents
Advertisement
Connecting to the Network
Figure 3-9
1 RJ21 straight connector
2 RJ21 port connector
3.
To install an RJ21 right‐angle connector, refer to Figure
a.
b. Tighten the two screws to secure the RJ21 angle adapter to the RJ21 port
c.
d.
3-16 Installation
Connecting a Twisted Pair Using RJ21 Straight Connector
Â
À
Note: When installing more than one RJ21 right-angle connector, start with the bottom-
most front-panel RJ21 connector so that the cables will dress properly over the front panel
as shown in
Figure 3-10
If using an optional RJ21 angle adapter available from Enterasys Networks, insert
the angle adapter into the RJ21 port connector.
connector.
Insert the RJ21 right‐angled connector into the RJ21 angle adapter until the two
retaining clips snap into place. The RJ21 angle adapter allows the cables to be
positioned along the front panel of the device when using a right‐angle RJ21
connector.
Note: The cable pinouts for a 25-pair cable (RJ21) can be found in the Cabling Guide.
Refer to "
"Related Documents"
Proceed to step
4.
Á
Â
3 Retaining screws
4 GROUP SELECT button
.
on page xvi for details on how to obtain this document.
Ã
3‐10 and proceed as follows:
Advertisement
Table of Contents
Troubleshooting
