Table of Contents
Advertisement
Installing a PCMCIA Flash Card
Installing a PCMCIA Flash Card
The control module PCMCIA flash card contains a version of the system image software that is
installed at the factory. If you have a more recent system image and want to boot the X-Pedition
using the newer software, you must boot either from a PCMCIA card or from a TFTP server.
To install a PCMCIA card:
1.
Power off the X-Pedition.
: Do NOT install or remove a PCMCIA card while the X-Pedition is running.
Cautions
2.
Insert the PCMCIA card into the upper slot on the control module, pressing firmly to ensure
that the card is fully seated.
Note:
Only the upper slot is active. The control module cannot use two PCMCIA flash cards at
the same time.
3.
Lock the PCMCIA card into the slot with the locking mechanism.
4.
Power on the X-Pedition. (See Powering On and Booting the Software
5.
Once the X-Pedition is powered on and starts to boot up, any of the following scenarios may
occur:
84
Figure 36. Install a PCMCIA flash card in a Control Module
Enterasys X-Pedition 8000/8600 Getting Started Guide
on page
86.)
Advertisement
Table of Contents
