Dc Power Supply - Enterasys 8000/8600 Getting Started Manual

Hardware Overview

DC Power Supply

The X-Pedition DC power supply delivers 3.3, 5, and 12 volts DC to the X-Pedition's control
module(s), fan modules, and other components. A single DC power supply provides enough current
to operate a fully configured chassis—with the exception of certain line cards. For information
about these cards, refer to Installing Line Cards
Figure 6 shows the front view of an X-Pedition 8000 DC power supply.
The X-Pedition 8000 DC power supply has a three-terminal wiring block on the front panel,
consisting of a positive (+) terminal, negative (-) terminal and a safety ground. The DC supply is
designed to be powered by a 48-Volt DC source.
X-Pedition 8600 DC Power Supply.
The X-Pedition 8600 DC power supply has a five-terminal wiring block on the front panel,
consisting of two positive (+) terminals, two negative (-) terminals and a safety ground. The DC
supply is designed to be powered by a 48-Volt DC source.
18
To be installed in a restricted
!
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
PWR
SSR-PS-8-DC
instructions.
48/60V
SN
14A MAX
Figure 6. Front view of an X-Pedition 8000 DC power supply
To be installed in a restricted
!
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
PWR
instructions.
SSR-PS-16-DC
SN
48/60V
27A MAX
Figure 7. Front view of an X-Pedition 8600 DC power supply
on page 71.
Figure 7 shows the front view of an
Enterasys X-Pedition 8000/8600 Getting Started Guide