Enterasys 8000/8600 Getting Started Manual page 27

128MB DIMM), or 256MB (in two 128MB DIMMs). See Installing a Memory Upgrade
page 66 for the upgrade procedure.
External Controls
The control module has the following external controls. Where appropriate, this guide describes
how to use the controls.
• Male DB-9 Data Communications Equipment (DCE) port for serial connection from a
management terminal. Use this port to establish a direct CLI connection to the X-Pedition. The
default baud rate is 9600.
• 10/100BASE-TX out-of-band Ethernet management port for network management. The port is
configured as a Media Data Interface (MDI). Use this port to establish a management
connection to the X-Pedition over a local or bridged Ethernet segment.
• Reset switch (RST). Use this switch to reboot the X-Pedition's CPU.
• PCMCIA flash memory slots. These slots let you install system image software upgrades as well
as older system image software versions.
Note: You can install a PCMCIA flash in slot 0 only. You cannot use two PCMCIA cards at the
same time.
LEDs
LED
OK
HBT
ERR
DIAG
GREEN
YELLOW
Hot Swap
Enterasys X-Pedition 8000/8600 Getting Started Guide
Table 1. Control Module LED Indicators
Condition Status
On Ready for operation or configuration.
Flashing Booting or waiting for configuration.
On Remains on for 5 seconds at power-up.
On Remains on for 5 seconds at power-up.
On Error occurred.
On Remains on for 5 seconds at power-up.
On The diagnostics are running.
On Link on ethernet port.
Flashing Activity on port.
On CM4 is active.
Off CM4 is redundant or offline.
Hardware Overview
on
15