The [Accessibility] Key - Konica Minolta bizhub C452 Copy Manual

4.7

The [Accessibility] key

4.7 The [Accessibility] key
This section describes the procedures for configuring settings for the control panel and adjusting the touch
panel.
0 To return to the basic settings screen from the Accessibility Setting screen, press the [Accessibility] key,
the [Reset] key or [Close].
0 In the Enlarge Display screen, [Default Enlarge Display Settings] appears, enabling you to configure
default settings for use in the Enlarge Display mode using the copy or fax/scan functions.
%
Press the [Accessibility] key.
Page 1/2
Page 2/2
Settings
Touch Panel Adjustment
bizhub C652/C652DS/C552/C552DS/C452
Adjust the position of touch panel buttons when they do not respond cor-
rectly because they may not be correctly aligned with the position of the
actual touch sensor.
• The touch sensors are not aligned in the touch panel if pressing [Touch
Panel Adjustment] does not activate any action. Press the [1] key on the
keypad.
• Press the four check point buttons ([+]) on the touch panel adjustment
screen while listening on a buzzer sound each time. When the checking
by pressing the check point buttons is completed successfully, the in-
dicator on the [Start] key lights up in blue. Press the [Start] key.
• The check point buttons ([+]) can be pressed in any order.
• To perform adjustment again, press the [C] (Clear) key, and then press
the four check point buttons ([+]) again.
• To cancel the touch panel adjustment process, press the [Stop] or [Re-
set] key.
• If the touch panel cannot be adjusted, contact your service represent-
ative.
4
4-12