Konica Minolta bizhub C452 Copy Manual page 77

5.1 Basic
Settings
Offset Yes/No
Fold/Bind
Staple
Punch
bizhub C652/C652DS/C552/C552DS/C452
Specify whether to separate each set of copies from another set in the output
tray when copying multiple sets of multi-page originals.
When the Finisher or Job Separator JS-504 is not installed:
If the following conditions are met, printed copies are fed out and sorted in an
alternating crisscross pattern.
• 8-1/2 e 11, A4 or B5 paper is used
• Paper of the same size and type is loaded with the w orientation in one pa-
per tray and with the v orientation in another tray
• Auto paper selection is specified for the paper size setting
When the Finisher or Job Separator JS-504 is installed:
The copies are fed out and stacked on top of each other with each set shifted
to separate it.
When the Saddle Stitcher SD-508 is installed on the Finisher FS-526:
Half Fold
Z-Fold
To configure the Z folding setting, install the Z Folding Unit ZU-606.
When the Saddle Stitcher SD-509 is installed on the Finisher FS-527:
Half Fold
Staples copies in corner or at two points before they are output.
Punches holes in copies before they are output.
1
Center Staple & Fold
Center Staple & Fold
5
Tri-Fold
5-11