Konica Minolta bizhub C452 Copy Manual page 104

5.4 Application
Settings
Margin Position
Image Shift
Adjust Value
Original Direction
d
Reference
To set the zoom:
Press [Basic] ö [Zoom].
bizhub C652/C652DS/C552/C552DS/C452
Select an option from [Auto], [Left], [Top] and [Right].
When Auto is selected, the binding position is automatically set.
• This function automatically determines the binding position according to
the orientation of the loaded original. If the original length is 11-11/16
inch (297 mm) or less, a binding position along the long side of the paper
is selected. If the original length is more than 11-11/16 inch (297 mm), a
binding position along the short side of the paper is selected.
• The binding position is set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back. If
the document is loaded in any other orientation, this setting fails.
Adjust the image position according to the binding margin.
Change Back Shift Adjust the image position on the back side of the
paper in the 2-sided copy mode.
• North American model (inch): Configure the width of the binding margin
(1/16 inch to 3/4 inch) with pressing [+] and [-]. When [None] is selected,
the binding margin width is set to 0 inch.
• European model (cm): Enter the width of the binding margin (0.1 mm -
20.0 mm). When [None] is selected, the binding margin width is set to 0
mm.
Select the orientation of the original loaded into the ADF or placed on the
original glass.
5
5-38