Registering A User Using Data Administrator - Konica Minolta bizhub C452 Copy Manual

10.1 Using an authentication unit (biometric type)
5
Press [Edit].
6
Place your finger on the authentication unit to scan the finger vein pattern.
% Scan the finger vein pattern three times; reset the same finger each time and then press [Scan] for
each scanning.
% After scanning the finger vein pattern, place the same finger on the authentication unit, and press
[Authentication Test].
% If your finger vein patterns have been authenticated in the authentication test, press [New]. If
authentication has failed, retry scanning the finger.
7
Press [Close] twice.
8
Enter the user name and password.
9
Configure function permission settings as required.
10
Press [OK].
11
Press [Close].

Registering a user using Data Administrator

To use Data Administrator, configure this machine, and set up Data Administrator. For setup, install the
BioDriver (USB-Driver) of the authentication unit, and then install Data Administrator Bio Plugin.
NOTICE
Before setup, install Data Administrator V4.0 or later in your computer. For the Data Administrator operating
environment and installation procedure, refer to the Data Administrator User's Guide.
bizhub C652/C652DS/C552/C552DS/C452
10
10-6