Log Sense Command Descriptor Block - Maxtor Atlas 10K V Product Manual

5.11.1

LOG SENSE Command Descriptor Block

The Command Descriptor Block for the LOG SENSE command is shown in Table
5-41. Table 5-42 contains field descriptions.
Table 5-41
Bit
Byte
0
1
2
3 – 4
5 – 6
7 – 8
9
Table 5-42
Field
PPC
SP
PC
Page Code
Parameter Pointer
Allocation Length
LOG SENSE Command Descriptor Block-Data Format
7 6 5
Reserved
PC
LOG SENSE Command Descriptor Block-Field Descriptions
The Parameter Pointer Control bit controls the type of parameters that can be requested
from the drive. This bit must be 0, indicating that all log parameters for the specified page
(subject to the allocation length specified) are returned to the initiator.
The Save Pages bit specifies whether the parameters are to be saved. This bit must be 0,
indicating that no parameters are to be saved and are reset at power-on or by a TARGET
RESET.
The Page Control field defines the type of parameter values to be selected. The field must
be 01b indicating that the current values are to be returned. Mode 11b (return default val-
ues) is not supported because all counters have a default value of 0.
The value specified as the Page Code determines the page to be returned. Table 5-40 con-
tains a list of supported log pages and their page codes.
This field is related to the PPC field. This bit must be 0.
This specifies the number of bytes of data that the drive is allowed to pass during the
DATA IN phase. The requested page is truncated if its length exceeds the number of bytes
specified in this field.
4 3
Operation Code (4Dh)
Page Code
Reserved
Parameter Pointer
Allocation Length
Control
Description
Maxtor Atlas 10K V
2 1 0
PPC SP
5-31