Maxtor Atlas 10K V Product Manual page 184

Sense
Key
0x04
Hdwe Error
5-126 Maxtor Atlas 10K V
Sense Sense
Code Qualifier
0x40 0x80 Unknown HW problem
0x40 0x82 Hardware Bug Check (check Info field)
0x40 0x83 Failed HDA test.
0x40 0x84 Failed PCB test.
0x40 0x85 EDC check failed.
0x40 0x86 Controller FIFO over/underflow error.
0x40 0x88 DIAG: Drive failed to read servowriter serial number.
0x40 0x89 DIAG: Failed XOR test.
0x40 0x90 EDC Check Failed 0
0x40 0x91 EDC Check Failed 1
0x40 0x92 EDC Check Failed 2
0x40 0x93 EDC Check Failed3
0x40 0x8A Servo restart failed after set RPM command
0x40 0x8C LBA mismatch error
0x40 0x8D ETM test failure, drive failed to spin
0x40 0x8E Could not achieve target RPM
0x40 0xA0 Test did not complete
0x40 0xA1 Test completed successfully, but failed.
0x40 0xA2 Invalid parameter was received.
0x40 0xA3 Invalid data in servo record. Prevented algorithm from completing.
0x40 0xA4 Servo record did not complete
0x40 0xA5 Read seek failed
0x40 0xA6 Write seek failed
0x40 0xA7 Raw seek failed
0x40 0xA8 Servo Diagnostic Test running.
0x40 0xA9 Invalid 97/98 super cmd seq. Must send 97 before 98
0x40 0xAA Super Command 97 already running
0x40 0xAB Complex magnitude is zero
0x40 0xAC Could not complete the low-level BCV write function
0x40 0xAD Got a divide by zero error in complex divide.
0x40 0xAE WGATE negated due to shock or bump during BCV write
0x40 0xAF Servo Death occurred during a BVC write operation
0x40 0xB0 Seek command completion timeout occurred
0x40 0xB1 Read an impossibility high number of good BCVS on this
0x40 0xB2 No read passes resulted in enough test BCVs being read
0x40 0xB3 The last read pass for test BCVs was good but shouldn't be
0x40 0xB4 DestinationLoc expected vs actual mismatch. servo death recovery
0x44 0x00 Logical assertion (firmware consistency check)
0x44 0x84 Insufficient buffer memory for operation
0x90 0x01 Serial Port Packet Receive Error
Meaning