Activity Led For Sca Connector Versions - Maxtor Atlas 10K V Product Manual

Option
Option 1 – Spin Up When Power is Applied
Option 2 – Spin Up After Delay
Option 3 – Spin Up on START Command
Reserved
3.4.3.4 Activity LED for SCA-2 Connector Versions
The drive provides the output BUSY_OUT signal to power a user-supplied activity
LED.
The output indicates the drive is performing a SCSI operation. To use this output,
connect a user-supplied LED cathode to the BUSY_OUT connection, pin 77 on
the SCA Connector (Figure 3-4). The LED anode must be attached to the proper
+5 VDC supply through an appropriate current-limiting resistor.
Table 3-3
Spin Up on Power On Options
STAGGER_SPIN
(Pin 78)
Open
Ground
Open
Ground
Maxtor Atlas 10K V 3-13
DELAY_SPIN
(Pin 38)
Open
Open
Ground
Ground