Supported Diagnostic; Translate Address Page - Maxtor Atlas 10K V Product Manual

Field
If the PF bit is 0 and the SelfTest bit is 1, the drive runs its self-test routine. GOOD status is re-
turned to the initiator if the self-test passes. CHECK CONDITION status is returned along with
SelfTest any available sense data if the self-test fails.
This field is ignored if the PF bit is 1.
DevOnl Any value in this field is ignored by the drive.
UnitOfl Any value in this field is ignored by the drive.
When the Parameter List Length field is non-zero, the value specifies the length (in bytes) of the
parameter list that is to be transferred from the initiator to the drive during the command's data-
Parameter List
out buffer transfer.
Length
This field is only valid when the PF bit = 1 and must be 0 when the PF bit is 0.
5.38.1 Supported Diagnostic Page List
Table 5-193 shows the Supported Diagnostic Page List that can be supplied with a
SEND DIAGNOSTIC command to request that the Supported Diagnostic Page List
be returned after the next RECEIVE DIAGNOSTIC RESULTS command.
Bit
Byte
0
1
2 - 3
5.38.2

Translate Address Page

Table 5-194 shows the Translate Address Page that can be supplied with a SEND
DIAGNOSTIC command to request that the Translate Address Page be returned after
the next RECEIVE DIAGNOSTIC RESULTS command.
Bit
Byte
0
1
2 - 3
4
5
6 - 9
10 - 13
5-142 Maxtor Atlas 10K V
Table 5-193
Supported Diagnostic Page List-Data Format
7 6
Table 5-194
Translate Address Page-Data Format
7 6
Reserved
Reserved
Description
5 4 3
Page Code (00h)
Reserved
Page Length (00h)
5 4 3
Page Code (40h)
Reserved
Page Length (0Ah)
Address to Translate
(LBA Format)
Reserved
2 1 0
2 1 0
Supplied Format
000b (LBA)
Translate Format
101b (Physical Sector)