Maxtor Atlas 10K V Product Manual page 213

Table 5-219
WRITE SKIP MASK Command - Field Description
Field Description
This field specifies the first logical block of the corresponding WRITE (10) COMMAND. This
Logical Block Ad-
allows a SEEK to begin immediately. The LBA of the following WRITE (10) command must be
dress
the same as the LBA of the Write SKIP MASK command,
This field indicated the length in bytes of the skip mask. The mask is up to 64 bytes, giving a data
address capability of 256K. The mask consists of a sequence of bits where a "1" bit is for the blocks
of data to be transferred and a "0" for the blocks of data that are to be skipped. The first "1" bit of
Skip Mask Length
the mask corresponds to the first LBA to be transferred. Any unused bits at the end of the last byte
in the mask must be set to 0. The mask is transferred in the data-out buffer transfer of the skip mask
command.
This field must be equal to the transfer length in the linked WRITE (10) command. The transfer
Transfer Length length field must be equal to the number "1" bits in the skip mask. If a WRITE (10) is used with
0 as the transfer length, a transfer length of 256 data blocks is implied.
5-155
Maxtor Atlas 10K V