Maxtor Atlas 10K V Product Manual page 180

Sense
Key
0x03
Medium Error
0x04
Hdwe Error
5-122 Maxtor Atlas 10K V
Sense Sense
Code Qualifier
0x15 0x81 Servo Write Not OK
0x15 0x82 Servo Read Not OK
0x15 0x83 Spoke address error
0x16 0x00 Data synchronization mark error
0x16 0x83 Spoke synchronization mark error
0x19 0x00 MCS is invalid
0x19 0x01 Unknown defect list
0x19 0x03 Bad grown defect list
0x19 0x80 Replacement block bad
0x19 0x81 Found two bad RBNs
0x27 0x00 Write protected
0x31 0x00 Format corrupted
0x31 0x01 Format command failed
0x32 0x00 No available replacement block
0x32 0x01 Failed replacement I/O (servo dead?).
0x41 0x86 Required HW process did not complete
0x44 0x80 Error writing FileSystem (neg cyl) file
0x44 0x81 Error reading FileSystem (neg cyl) file.
0x80 0x00 Forced error
0x80 0x10 Block Slow PLL Error
0x80 0x11 Split SLow PLL Error
0x80 0x12 Block state machine disabled error
0x82 0x20 Spoke-to-spoke time error
0x02 0x00 No seek complete
0x03 0x00 Write fault
0x06 0x80 PES calibration results are bad
0x06 0x81 BIAS calibration results are bad
0x06 0x82 ID GAMMA calibration values out of range
0x06 0x83 Recal record timeout
0x06 0x84 Seek fail during feed forward scale Cal.
0x06 0x85 Initial track grab failed.
0x06 0x86 Seek failure during Bias Calibration
0x06 0x87 Seek failure during KT/J Calibration
0x06 0x88 Seek failure during PES Calibration
0x06 0x89 Recal servo not ready
0x06 0x8A Switch Point calibration results are bad
0x06 0x8B Recal track number bad
0x06 0x8C Seek failure during switch point cal
0x06 0x8D Not all Head(s) in USER head map were found alive
0x06 0x8E Valid SAMs not found!!!
0x06 0x8F Sync To Disk Spokes failed
Meaning