Maxtor Atlas 10K V Product Manual page 79

Field Name Value
Peripheral Qualifier
Peripheral Device
ANSI Version
AERC
NormACA
Port
MultiP
Mchngr
Addr16
TrmTSK
Response Data
Format
RelAdr
WBus 16 0 or 1
Sync
Linked
CmdQue
SftRe
VS
Product value in
Identification this field
Clocking
QAS 1 (U160)
IUS 1 (U320)
Note:
Table 5-25
Standard Inquiry Data Page-Field Descriptions
0 Non-zero if initiator selects an invalid logical unit.
0 0 indicates that this is a Direct Access Device.
3 ANSI SCSI Level 3 (SCSI-3) is supported.
0 Asynchronous Event Reporting is not supported.
0 Does not support setting NACA in CDB Control word.
0 Only used when MultiP = 1.
0 This field set to 1 if it is a multiport device.
0 Not embedded in or attached to a medium changer
0/1 16-bit wide SCSI address
0 TERMINATE TASK Function is not supported
2 This Standard Inquiry Data is in the format specified in the International Standard.
0 Relative Addressing is not supported.
The WBus bit is 1 if the drive supports 16-bit data transfer. The bit is 0 if the drive only
supports 8-bit transfer.
1 The drive supports Synchronous Data Transfers.
1 Linked Commands are supported.
1 The drive supports Tagged Command Queuing
The drive implements the hard reset option in response to assertion of the SCSI Bus reset
0
line.
0 Vendor Specific
The
ATLAS10K5_73WLS, ATLAS10K5_147WLS, ATLAS10K5_300WLS
ATLAS10K5_73SCA, ATLAS10K5_147SCA, ATLAS10K5_300SCA
is:
The contents of this field define the setting of the double-edge clocking option (See Chap-
11 ter 6). Note that the clocking field does not apply to asynchronous transfers of data. Op-
tions available are:
Code
00b
01b
10b
11b
Quick Arbritrate Support. If the value of this field is 1, it indicates that the device server
supports the quick arbitrate feature. A value of 0 indicates that the device server does not
support this feature. 1 is default setting.
Information Unit Supported. If the value of this field is 1, it indicates that the device server
supports information units. A value of 0 indicates that the device server does not support
information units. Default is 1.
Vendor Information, Product Identification, and Product
Revision Level are returned as shown in Table 5-22.
Description
Description
Indicates the device server supports only Single Transition
(ST)
Indicates the device server supports only Double Transition
(DT)
Reserved
Indicates the device server supports ST and DT
Maxtor Atlas 10K V
5-21