Alarm Feature Programming; Remote Start Feature Programming - Marksman Extreme Series X9 Installation Manual

Alarm Feature Programming (Group 3)
Step 4
Exit Programming
OFF

Remote Start Feature Programming

Examine the 2 feature charts enclosed and decide which features will get changed. Circling the feature to be
changed will make the programming process much easier to perform.
Step 1
O FF
ON
With the ignition switch in the OFF position, Turn the
ignition switch On - Off - On - Off - On - Off
Use the transmitter buttons as illustrated to adjust the features required. Keep repressing the transmitter button
that relates to the feature you want to adjust until the correct amount of chirps/beeps is heard. Move on to the
next feature.
One Chirp
Button One LED Pulse
(Default Setting)
Gasoline
Engine
Five Chirps
Five LED Pulses
Diesel DBI
(continued)
Turn On the Ignition
3 long chirps & 3 flashes of the
parking lights will confirm exit of
the programming mode.
3X
Before 15 seconds has passed, push and release the
valet switch 8 times holding the button down on the
8th press. Wait until four (4) short chirps/beeps + one
(1) long chirp/beep is heard. Release the button. You
are now in "Remote Start Feature Programming"
mode.
Step 3
Remote Start Feature Programming
Two Chirps Three Chirps
Two LED Pulses Three LED Pulses
Diesel Engine and Diesel Engine and
10 Second 15 Second
Warm-Up Timer Warm-Up Timer
Note: Waiting 15 seconds after the
last command will also cause the
system to automatically exit the
programming mode.
Step 2
7X + 1X (Hold)
Four Chirps
Four LED Pulses
Diesel Engine and
20 Second
Warm-Up Timer
21