Table of Contents
Advertisement
LCD Transmitter Setup and Operation
Press Buttons at the Same Time: Then Press Button Within:
+
+
+
Battery Replacement
Interference
The transmission range may decrease if the system encounters interference from tall structures or
stronger radio frequencies such as high-voltage power lines.
Alarm Indicators
LED Indicators
LED
Off
Slow Flashing
Fast Flashing
On Solid
2 Flashes - Pause
3 Flashes - Pause
4 Flashes - Pause
5 Flashes - Pause
6
+
+
Function
System is Disarmed
System is Armed
System in Automatic Arming
System in Valet Mode
Zone 2, Trigger on Trunk/Hook
Zone 3, Trigger on Door Switch
Zone 4, Trigger on Shock Sensor
Zone 5, Trigger on Ignition Switch
(continued)
System Function
Switching to 2nd Vehicle
or Returning to 1st
5 Sec.
Vehicle Operation
Melody / Vibration Mode
5 Sec.
Power Save Mode
5 Sec.
LCD Screen Lamp
Turns On for Five Seconds
System Status Check
3 Sec.
Clear the Flash Icon
3 Sec.
and Melody Sound
The LCD remote control is powered by a 1.5 Volt
AAA Alkaline battery. When the power of the
battery weakens the battery icon
displayed on the screen. When the old battery is
replaced with a new one, there will be a beep to
indicate the power is up. To replace the battery,
follow the steps in the illustration at left.
Note: Press the
battery compartment is empty, then insert the
new battery.
button two times when the
will be
Advertisement
Table of Contents
