Alarm Feature Programming - Marksman Extreme X3 Installation And Owner's Manual

Programming the Transmitter
Step 3
Press the "Lock" button on the first
transmitter until you hear a
confirmation chirp/beep. The
transmitter is now coded into the
system.

Alarm Feature Programming

Examine the feature chart enclosed and decide which feature will get changed. Circling the feature to be changed
will make the programming process much easier to perform.
Step 1
With the ignition switch in the OFF position, turn the
key On-Off
1. Press the valet switch the number of times required to access the feature that needs
Step 3
adjusting.
2. Press the indicated transmitter button and listen for the chirp sequence to set the
feature.
Example:
Step 4
Repeat for each additional
transmitter.
Step 2
Within 10 seconds, push and release the valet switch 3
times. The siren/horn will emit 1 long chirp or beep.
Push and release the valet switch 3 more times. The
siren/horn will emit 1 long chirp or beep. You are now
in "Alarm Feature Programming" mode.
- Complete steps 1,2 and 3 to enter feature program mode
- Push the valet switch 2 times, (Selects Manual/Automatic arm
programming) the siren will chirp 2 times and the LED will flash
2 times.
- Change the feature to "Automatic Arming" by Pressing the
on the transmitter. The siren/horn will chirp 2 times.
Step 5:
Exit Program Mode
When finished, turn Off the ignition
key or wait for 15 seconds to get out
of transmitter programming mode.
You will hear 3 long chirps/beeps.
You are out of the transmitter
programming mode.
+
3X
3X
button
7