Programming The Lcd Transmitter - Marksman X11 Owner's Manual

Programming the LCD Transmitter

Button Description
LCD Screen Lamp Turns ON for
SET
Five Seconds
Timer Programming Mode
SET
Power Save Mode
SET
SET (3X) Clear the Flash Icon and Melody Sound
on the LCD Screen
SET & LOCK Button Lock Enabled/Disabled
SET & UNLOCK Melody/Vibrate Mode
Program Count Down Timer
+
SET (10 m, 20 m, 30 m, 1 hr, 1.5 hr, 2 hr)
Enable/Disable Beep Sound While
+
SET
Pressing Button
Display Illumination On/Off
SET - SET -
Switch Between 1st Car RF Control and
+
SET -
2nd Car RF Control
Screen Lamp On
Press and hold the "SET" button one second, with the melody sound and the LCD screen lamp
will turn on for 5 seconds.
Power Save Mode
While in the Power Save Mode, the LCD transmitter uses "0" current to save the battery power.
1. Press and hold the "SET" button for 5 seconds. One melody will sound from the transmitter
and the LCD will show "SAVE". You are now in the Power Save Mode.
2. Under the Active Arming Mode and Disarm Mode. Turn the ignition switch to the "ON" position.
The LCD remote transmitter will automatically enter the Power Save Mode.
Exit Power Save Mode
Press any button on the LCD transmitter to exit the Power Save Mode.
Clear the Flash Icon and Melody Sound
Press the SET button 3 times within 3 seconds and it will clear the flashing icon and melody
sound on the LCD transmitter.
Operation
Press and Hold for 1 Second
1 Melody Sounds to Confirm
Press and Hold for 3 Seconds
2 Melody Sounds to Confirm
Press and Hold for 5 Seconds
1 Melody Sounds to Confirm
Press within 3 Seconds
Press within 3 Seconds
Press within 3 Seconds
Press within 3 Second Cycles
Leave the Buttons Starting Count
Down then Timer Icon Flashes
Press for 2 Seconds
3 Seconds between "SET - SET"
and Hold for 2 Seconds
+
Hold for 2 Seconds
19