Marksman Extreme Series X9 Installation Manual page 24

Engine Crank Detection Programming Explanations
3. Elapsed Timer: This method is the easiest for installation but is not always the best method for year round
usage (Summer and Winter). To operate this method, you will program a specific time window for the remote
start to crank the engine. Battery strength, environment and the aging process of the vehicle may require the
timer to reset from time to time or season to season.
Step 3A Crank Detection Programming and Procedure
Press Chirp/ Checking
Buttons Type
LED Flash
Voltage
1
Type
+
Step 3B Crank Detection Programming and Procedure
Press
Chirp/ Checking
Buttons Type
LED Flash
Tachometer
2
Type
+
Step 3C Crank Detection Programming and Procedure
Press Checking
Chirp/
Buttons LED Flash Type
3 Fixed Crank
Mode
+
24
Follow Programming and Test Procedure
A. Press two times to start the engine. Allow engine to run for more
than 10 seconds.
B. If engine starts without cranking too long or too short and runs for more
than 10 seconds, press to exit programming mode (3 chirps confirm
exit). Programming is complete.
C. If the engine shuts off before 10 seconds, press
check level" to "hi check level" (2 chirps). Repeat A/B above.
D. If the engine cranks too long or too little, press
crank duration (see chart enclosed). Repeat A/B above.
Follow Programming and Test Procedure
A. Learn the engine idle RPM.
1. Push and release the button on the transmitter
2. Start the engine with the ignition key and allow the choke to turn off.
3. With the engine at true idle speed, press and hold the valet switch
until you hear (1) long chirp and the LED is on solid for two seconds.
3A. If you do not get a response from holding down the valet switch,
check your tach connection. It may be loose or incorrect.
4. Turn off the ignition key.
B. Press two times to start the engine. Allow engine to run for more than
10 seconds.
C. If engine starts without cranking too long, press
mode (3 chirps confirm exit). Programming is complete.
D. If the engine cranks too long, press
"low check level" (1 chirps). Repeat B/C above.
Follow Programming and Test Procedure
A. Press two times to start the engine. Allow engine to run for more than
10 seconds.
B. If engine starts without cranking too long or too short, press
programming mode (3 chirps confirm exit). Programming is complete.
C. If the engine cranks too long or too little, press
crank duration (see chart enclosed). Repeat A/B above.
(continued)
to change "low
to select a different
to exit programming
to change "high check level" to
to exit
to select and different