Marksman Extreme Series X9 Installation Manual page 13

Wiring
(continued)
HC6 White 6-Pin Connector
White Wire: (-) 200mA Output
Dome Light Control Output:
This wire becomes grounded when the dome
light controls circuit of the alarm is active. The
current capacity of this wire is 200mA. This wire
can control the operation of the interior lights. An
optional relay can be used as shown.
A. Upon disarming, the interior lights will
remain on for 30 seconds.
B. If the vehicle is violated, the interior light
will flash for the same duration as the siren.
Pink Wire: 200mA Ignition #3 Output (Programmable Operation)
Some vehicles may require a 3rd ignition
connection in order to start the vehicle engine.
The Pink wire provides a 200mA (-) ground
output that becomes active during engine
cranking (default Setting).
If the vehicle starting system does not require a
3rd ignition connection, this wire may also be used
for other functions (See Alarm Feature
Programming Group 3 for programming
information)
Transponder Interfacing Using ALA984 Relay (may also use optional RS-TIM bypass module):
If the vehicle has transponder system installed, you will need to bypass the system while the vehicle is
operating under the control of the Remote Start Unit. To do this, follow these steps:
1. You will need a transponder key that's already programmed to the vehicle.
2. Remove the trim around the ignition switch.
3. Wrap a thin (30awg) wire tightly around ignition switch 6 to 8 times and secure it.
4. About 6" down line make another loop of approximately 2" diameter.
5. Place the key inside this loop and secure it to the loop.
6. Connect one end of the 30 awg wire to pin (87) of the relay module.
7. Connect the other end of the loop wire to pin (30) of relay module.
8. Connect pin (86) to ignition, connect pin (85) to the pink wire of the white 20-pin mini connector.
I
gnition 3 Output:
Some newer vehicles use a third ignition
wire which is required to start and keep
the vehicle's engine running. If this is the
case, wire an IGN 3 Relay (not supplied)
as shown:
DO NOT CONNECT ANY VEHICLE
CIRCUITS TOGETHER, THEY ARE
ISOLATED FOR A REASON.
Common Door Pin Trigger
87
White Wire
87a
85
86
30
White 6-Pin
Connector
Ground Wire or +12V Depending
on Circuit Requirements
Pink Wire
87
87a
White 6-Pin
86 85
Connector
30
Ignition
Switch
87
White
Pink Wire
6-Pin
87A
Connector
86
+12 Volt Ignition
Dome
Light
+12V
Constant +12V:
Fused 25A Capable
Ignition: 3-Wires from
Ignition Key Switch
Transponder Key
85
30
13