Turbo Timer Mode Operation; Chirp Status Indication; Parking Light Flash Indicators; Alarm Operating Conditions - Marksman EXTREME X7 Owner's Manual

Remote Start Operation
Turbo Timer Mode (Also See Installation Manual)
Turbo Timer mode keeps the engine running after arriving at you destination for a programmable
time period of 1, 3 or 5 minutes. This allows the system's time to conveniently cool down the
turbo after you have left the vehicle.
To Activate:
1. While the engine is running, set the emergency brake and place the transmission to "Park".
2. Before turning off the engine, press and release
will flash to indicate the remote start has entered "Turbo Timer" mode.
3. Remove the "Ignition Key" from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The engine continues running until the pre-programmed time
elapsed.
Chirp Status Indications
Chirp Function
1 Chirp Arm
2 Chirps Disarmed
3 Chirps Defective Reminder
4 Chirps Disarm / Triggered
6 Chirps Car Locator

Alarm Operating Conditions

Siren, Horn Parking Light LED
1. Arming 1 or 3 Chirps 1 Flash
2. Disarming 2 or 4 Chirps 2 or 3 Flashes Fast Flash
3. Trigger Alarming Flashes
4. Panic Alarming Flashes
5. Car Locator 6 Chirps 12 Flashes
LED Status Indications
LED Function
Off Disarmed
Slow Flash Armed
Fast Flash Passive Arming
On (Solid) Valet Mode
(continued)
and
Parking Light Flash Indications
Parking Lights
1 Flash
2 Flashes
3 Flashes
12 Flashes
Constant On
Doors
Slow Flash Locking
Unlocking
Slow Flash
LED Function
2 Flashes... pause Zone 2: Trigger on Trunk/Hood
3 Flashes... pause Zone 3: Trigger on Door Switch
4 Flashes... pause Zone 4: Trigger on Optional Sensor
5 Flashes... pause Zone 5: Trigger on Ignition Switch
buttons at the same time. The light
Function
Arm
Disarmed
Disarm / Triggered
Car Locator
Under Remote Control
Starter Dome Light
Disable
Turns on for 30 Seconds
Disable Flashes
Flashes
9