Epson LQ-2550 Technical Manual page 191

When the paper release solenoid assembly is removed, perform the following adjustment:
Section 4.3.2 Paper Feed Motor Backlash Adjustment (Page 4-4 1)
ASSEMBLY POINTS:
The lead wires from the sensor should be drawn along the frame to the rear of the printer and hooked
by the tabs on the loading frame.
Before mounting the paper release lever, confirm that the paper release planetary lever and the
release trigger plate are in their correct positions as shown in Figure 4-49.
The positional relationship between paper release lever and paper release support lever is shown "
in Figure 4-50.
Figure 4-49.
Figure 4-50. Positional Relationship Between Paper Release
ADJUSTMENT REQUIRED
Figure 4-48. Path of Sensor Lead Wires
Positional Relationship Between Release
Planetary Lever and Release Trigger Plate
o
.-
0
Release
Lever and Paper Release Support Lever
4-29
REV.-A