Battery Removal - Epson LQ-2550 Technical Manual

Battery Removal

4.2.4.5
Remove the upper case. (Refer to Section 4.2.2.)
Step 1:
Disconnect connector CN7 on the ROMA board.
Step 2:
Step 3: Insert a slotted screwdriver into the groove of the lower case, then unlock the tab of the battery
case.
Remove the battery together with the battery case.
Step 4:
When connector CN7 for the battery is disconnected, perform the following adjustment:
Section 4.3.5 Platen Gap Initial Value Write Operation (Page 4-46)
ASSEMBLY POINT:
When mounting the battery, push down the tab of the battery case with a slotted screwdriver so
that it can be smoothly inserted into the lower case.
Figure 4-18. Battery Removal
ADJUSTMENT REQUIRED
4 - 1 3
Battery Case
Screwdriver
/
G
I
REV.-A