Setting The Time - Brady POWERMark User Manual

Setting the time

Follow these steps to change the time on your system:
1) Hold down the Shift key and press the Date/Time key.
The Date and Time window displays.
2) Press the ↑ or ↓ key to move the cursor to the Set time option. Press Enter.
The Set Time window appears and displays the current system time.
3) Press the ↑ or ↓ key to move the cursor to an option you want to set. Then type a value
as shown in the following table.
Date option
Hours
Minutes
Seconds
AM/PM
4) Press Enter to close the Set Time window.
Label Design
Date and Time
Format setup . . .
Set time . . .
Set date . . .
Done
Press ↑↓, ENTER or ESC
Set Time
Hours (1-12):
Minutes (0-59):
Seconds:
AM/PM:
Type values, press ↑↓, ENTER or ESC
What it does
Sets the hour value. If the Time format option in the Format Setup window is 12
hours, enter a value between 1 and 12; if that option is 24 hours, enter a value
between 0 and 23.
Sets the minute value. Enter a value between 0 and 59.
Sets the seconds value. Enter a value between 0 and 59.
Sets the current time to AM or PM. This option does not appear if the Time format
option in the Format Setup window is 24 hours.
10
45
39
AM
3-25