Punch In/Out; What Is Punch In/Out Recording; Auto Punch In/Out; Preparation - Fostex D2424LVmk2 Reference Manual

Punch In/Out recording enables you to record over previously-recorded parts. See the diagram
below. For example, using the Punch In/Out function allows you to change an unsatisfactory guitar
solo. The D2424LVmkII offers two types of Punch In/Out functions. One is called Auto Punch In/Out,
in which you automatically re-record a specified part.
The other is called Manual Punch In/Out, in which you record data manually (using your foot to
operate an optional foot switch, model 8051). Both functions feature "Rehearsal mode" to enable
you to practice repeatedly until you are ready.
• Select a Program for Punch In/Out recording.
• Initialize the recorder.
• Check a sampling frequency of the recorder and external device.
<Notes>
• You can use the Punch In/Out recording only for Real tracks. If you wish to use Punch In/Out
recording for data on an Additional track, first move the data to the Real tracks.
• Before doing punch in/out, check that the SETUP mode " Chain Play? " menu is " Off. " If it is set
in other than " Off ," chain play will be executed.
To perform Auto Punch In/Out recording, you need to specify the Auto Punch In point (recording
start point) and the Auto Punch Out point (recording end point).

Preparation

Storing the edit points
(1) Refer to "Storing the edit points" to set the Auto
Punch In/Out points.
Store the Auto Punch In point to the [AUTO PUNCH
IN] key, and the Auto Punch Out point to the [AUTO
PUNCH OUT] key.
• Refer to page " 54 " for more information on
storing the edit points.
<Note>:
Make sure that you specify an Auto
Punch In point that precedes the Auto Punch
Out point. If the Auto Punch Out point precedes
the Auto Punch In point, " Void Out! " appears and
you will be unable to perform Auto Punch In/
Out recording.
Model D2424LVmkII Reference Manual (Punch In/Out)

Punch In/Out

What is Punch In/Out recording?

Auto Punch In/Out

Previewing and trimming the edit points
You can check the stored edit points by pressing the
corresponding memory keys to display them on the
LCD. You can also change the points if necessary.
In this example, use the Preview function to fine-
tune the point while previewing.
(1)
(2)
43
While the recorder is stopped, hold down the
[SHIFT] key and press the memory key.
Pressing the [AUTO PUNCH IN] key enables you to
listen to the sound at the AUTO PUNCH IN point
("previewing the sound rise [fade-out]").
Pressing the [AUTO PUNCH OUT] key enables you to
listen to the sound at the AUTO PUNCH OUT point
("previewing the sound fall [fade-in]").
Trim the edit point while auditioning the sound.
• Refer to page " 67 " for more information on
the Preview function.