Table of Contents
Advertisement
Model D2424LVmkII Reference Manual (MIDI Sync Function)
(3)
With the SETUP mode "Setting Offset mode," whether the MTC offset time will be output (ABS) at the ABS 00H
00M 00S 00F 00SF point or at the 001BAR 1BEAT 00CLK (bar/signature) point of the tempo map, is selected.
Refer to page " 115 ", SETUP mode "Setting Offset mode" for operating procedure and details.
(4)
A random offset time is set by the SETUP mode "Setting an MTC offset value."
Refer to page " 115 ", SETUP mode "Setting an MTC offset value" for operating procedure and details.
(5)
"00" is set with the SETUP mode "Setting the MIDI device number."
Refer to page " 120 ", SETUP mode "Setting the MIDI device number" for operating procedure and details.
(6)
Set to "Int." the clock setting by the SETUP mode "Setting the operating clock."
Refer to page " 120 ", SETUP mode "Setting the operating clock" for operating procedure and details.
(7)
Press the [DISP SEL] key while holding down the [SHIFT] key to change the time base display to MTC.
• Setup of the recorder (#2) <Slave 1> and (#3) <Slave 2>
(1)
Set the SETUP mode "Setting an MTC frame rate" to the same frame rate as in the recorder (#1).
Refer to page " 114 ", SETUP mode "Setting an MTC frame rate" for operating procedure and details.
(2)
Set the SETUP mode "Setting Offset mode" to the same mode as in the recorder (#1).
Refer to page " 115 ", SETUP mode "Setting Offset mode" for operating procedure and details.
(3)
Set the SETUP mode "Setting an MTC offset value" to the same offset time as in the recorder (#1).
Refer to page " 115 ", SETUP mode "Setting an MTC offset value" for operating procedure and details.
(4)
Set the SETUP mode "Setting the MIDI device number," to "01" in the recorder (#2), and to "02" in the recorder
(#3).
Refer to page " 120 ", SETUP mode "Setting the MIDI device number" for operating procedure and details.
(5)
Press the [EXECUTE/YES] key While holding down the [SHIFT] key, set slave mode to "On."
"CHASE" indicator will be flashing in the display.
(6)
Using the SETUP mode "Setting the slave type," set slave type to "Free."
* Slave type initial setting:
* Permissible setup item:
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page " 116 ", SETUP mode "Setting the slave type", for operating procedure and details.
(7)
Set to "Word" the clock setting by the SETUP mode "Setting the operating clock."
Refer to page " 120 ", SETUP mode "Setting the operating clock" for operating procedure and details.
(8)
Press the [DISP SEL] key while holding down the [SHIFT] key, to change the time base display to MTC.
Vari
Vari, Free, Once
86
Advertisement
Chapters
Table of Contents
