Rear Panel Section - Fostex D2424LVmk2 Reference Manual

13
1. Analog Input jacks 1~24
External analog audio signals to the D2424LVmkII are
input here. These are connected, for example, to
external mixer's group out (BUSS OUT) connectors.
<Note>:
Analog input/output can be switched for
balance (+4dBu)/unbalance (-10dBV) via the SETUP
mode. At initial setup, it is set for unbalance (-
10dBV).
2. Analog Output jacks 1~24
Analog audio signals (Channels 1-24) from
D2424LVmkII are output here. For example, this is
connected to the external mixer [TAPE IN] connector.
<Note>:
When using a current drive formatted to
96kHz 24 bits or 88.2kHz 24 bits, only [OUTPUT 1-
8] will be functional.
3. Optional Panel
The additional installation panel for the optional
Model 8346 (TC/SYNC card x1). Normally, it can be
used with the panel remained installed.
<Note>:
Installation of the option must be done by
our Fostex Service Station. For details, please inquire
at your nearest Fostex Service Station.
• For functions at installation of the optional Model
8346, please refer to " APPENDIX" on the last page
of this manual.
4. WORD IN terminating switch (75 )
This is the [WORD IN] port terminating switch (75 ).
Turn this ON when inputting an external word clock
signal into the [WORD IN] connector from digital
equipment.
5. WORD INPUT connector
Word clock signal from external digital equipment
is input here for the purpose of phasing with
external digital equipment.
Model D2424LVmkII Reference Manual (Names and Functions)

Rear panel section

1
12 11 10
(Connector: PHONE)
(Connector: PHONE)
(Connector: BNC)
2
8
9
6. WORD OUTPUT connector
Word clock signal from the recorder is output to
external digital equipment.
7. AC IN connector
The power cable packaged with this recorder is
connected here.
<Note>:
Always plug the power cable to the recorder
before plugging the cable into the wall outlet.
8. REMOTE THRU connector
(Connector: D-sub 9-pin)
RS-422 control signal (SONY 9PIN PROTOCOL or
Fostex System Exclusive Message) input from the
[REMOTE INPUT] connector is output here.
This is connected to the second recorder REMOTE
INPUT when controlling a multiple number of
recorders.
9. REMOTE INPUT terminating switch (100 )
This REMOTE INPUT terminating switch (100 ) is
switched ON for normal use of an inputted RS-422
control signal into the [REMOTE INPUT] connector.
When controlling a multiple number of recorders,
the last one only is switched ON; the others are
switched OFF.
10. REMOTE INPUT connector
(Connector: D-sub 9-pin)
External RS-422 control signal (SONY 9PIN PROTOCOL
or Fostex System Exclusive Message) is input here to
control this recorder.
19
3 4 5 6
7
(Connector: BNC)